|Web Width||from 1650mm / 65" to 2250mm / 88"|
|Maximum Unwind Diameter||1100mm / 43"|
|Option||1500mm / 59"|
|Maximum Rewind Diameter||700mm / 28"|
|Option||850mm / 33"|
|Maximum Speed||1000 m/min /3,300 ft/min|
|Minimum Slit Width||25mm / 0.8"|
|Maximum Slit Width||1100mm / 43"|
Servo driven unwind chucks
All AC Electric operation
raise and lower Digitally positioned unwind
Positive knife positioning device
Linear tracking slitting section
Overhead web path
Unique turret sequence
Optimum roll conditioning
flag detection camera
Moving splice table
Guider to knife positioning
Automatic knife positioning system
Rewind clamp cut off
Rewind stick down
1 Moving Splice Table (Option)
saves time and reduces waste. The splice table is supplied with clamps and vacuum, enabling the web to be held throughout the splicing procedure, providing a more accurate join.
2 Guider to Knife Positioning (Option)
Enables the first knife to be set from the edge guide sensor position, reducing waste pulled through the machine for alignment.
Digitally Positioned Unwind
All functions of the unwind, unwind arm positioning and edge guide control are motor driven, providing more accurate control, reduced power consumption and with no hydraulics, gives a cleaner environment.
3 Rewind Stick Down (Option)
Uses an automatic double-sided tape applicator and in conjunction with the Rewind Clamp Cut- Off, individual rewind web tails are stuck down on the finished reel and / or the cores.
4 Knife Positioning Systems
A variety of knife positioning systems from manually positioned to semi-automatic and fully automatic systems.
5 Linear Tracking Slitter Section
Minimising the distance between the knives and the rewind shaft provides better control of the slit webs ensuring the highest side wall quality.
6 Rewind Clamp Cut-Off (Option)
This clamps the web at each rewind shaft and cross cuts all slit webs, dramatically reducing the operator time required between sets.
7 Rewind Core Positioning
Provides two options for core positioning, from motorised laser positioning to semi-automatic servo core positioning.
8 Reel Stripping Device (Option)
Enables the complete set of reels to be removed from the rewind shafts at the same time.
9 Turret Support Device
EMPLOYED IN CONJUNCTION with a rotating turret, THE support device SECURES BOTH SHAFTS SIMULTANEOUSLY ALLOWING the turret to be rotated faster and reducing shaft fatigue.